How to put a mrdoright123 mold together

[Guest]

I was reading a thread on a forum about mrdoright123 molds . Apparently someone made a video that was less than flattering to mrdoright123 or herself .This woman didn't know how to put the mold together . I know they don't send directions so I thought I would explain it , in case someone else is having trouble.

You lay 1 side piece on a table with the outside facing down . Slide the bottom piece into the groove in the side piece . Take the ends and fit them in the grooves .Put the other side on matching the grooves . Put your hand on the mold to hold it together and turn it so 1 end is hanging over the table .Insert the bolt and wing nut , flip the mold around so the other side is hanging over the edge and again insert the bolt and wing nut . Turn the mold over and insert the bottom bolt and wing nut . It takes about 30 seconds.

HTH

 

[heartsong]

x

thanks kitn!

since the molds come assembled, i guess he figures it is self-explanatory!

took me forever-fumbling around the 1st time i had taken it apart to clean. now it seems like it practically goes back together by itself.

 

[Guest]

Exactly heartsong it really is so quick and simple if you know how :wink: just like everything else in life :shock:

 

[carebear]

getting it together was never among the multiple problems I had with DoRight (ha) molds. but the instructions might come in handy to some so thanks for posting.

 

[MRDORIGHT123]

A. SOAP MOLD ASSEMBLY;
1.LAY A SIDE PANEL FLAT 2.PLACE THE BOTTOM PANEL IN THE GROOVE 3.NOW PLACE THE TWO END PANELS 4.AND THEN PLACE THE SECOND SIDE PANEL ON TOP THEM.

B. PLACING BOLT CLAMPS;
1.HOLD BOTH ENDS TOGETHER AND ROLL THE MOLD ONTO ITS TOP AND PLACE THE CENTER BOLT CLAMP LOOSELY AND ONLY! SNUG TIGHTEN! 2.PLACE THE BOLT CLAMPS ON BOTH ENDS LOOSELY AND ONLY! SNUG TIGHTEN!

C. AFTER PRACTICE, ASSEMBLY WILL TAKE YOU LESS THAN 2 MINUTES AS FOR OUR TEN YEAR OLD AND LESS THAN 5 FOR OUR 75 YEAR OLD BEST FRIEND, SHE JUST WANTS TO MAKE SURE ITS JUST RIGHT THOUGH.

D. DO NOT WARP THE MOLDS OR CUTTER MOLD BY OVER TIGHTENING, NO NEED TO. ITS ALSO VERY OBVIOUS WHEN DOING SO. ESPECIALLY THE CENTER BOLT CLAMP.

F. I AM REALLY HERE TO HELP OUR SOAP MOLDS AND CUTTER MOLDS ARE BUILT TO LAST LIFE TIMES, SO PLEASE TAKE THE TIME TO CONTACT ME BEFORE LEAVING A LESS THAN DESIRABLE FEED BACK POSTING.

G. CONTACT PLEASE, PLEASE FEEL TO CALL ( TOLL FREE 1-877-890-0267 ) OR 1-360-910-1976

H. SHIPPING
THE POST OFFICE DOES NOT COUNT WEEKENDS. THEY WILL TAKE 2-3 BUSINESS DAYS PRIORITY OR THE MOST COMMON, 2-9 BUSINESS DAYS PARCEL POST GROUND. WE SHIP SAME BUSINESS DAY OF PURCHASE AND TAKE NO MORE THAN 2 BUSINESS DAYS. YOU WILL ALSO RECEIVE USPS TRACKING INFO. EMAIL VIA PAYPAL WHEN WE DO SHIP.