alcohol spray?

Soapmaking Forum

Help Support Soapmaking Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

momof7

Member
Joined
Dec 2, 2011
Messages
15
Reaction score
0
I've read many comments about spritzing the top of soap with rubbing alcohol to prevent ash. Is this just regular rubbing alcohol purchased over the counter or is different? Do you use it full strength or water it down? Are there other reasons for the use of rubbing alcohol?

Thank you for your help!
 
I use a 91 or 99% isopropyl rubbing alcohol. The sprayed batches never have ash, if I forget to spray I get major ash!
 
Hestey said:
I use a 91 or 99% isopropyl rubbing alcohol. The sprayed batches never have ash, if I forget to spray I get major ash!

Me too. When I used the lesser % alcohol (I think it's around 70%), I got some discoloration - little light color spots.

You can get the 92% at any major drug store.

Hi Hestey, nice to see you over here.
 
It removes surface bubbles from melt and pour soap, I've not seen it do anything to bubbles in CP.
 
Since it works to prevent ash from the top of a loaf, could I also use it to prevent ash on the bars after cutting? Just spritz the loaf before cutting? My gelled/HP soaps have never ashed but I get major (ugly!) ash on my tops and sides after cutting.
 
I've never had ash after I cut, but I don't see why it wouldn't help. Might as well give it a try! :D
 
It removes surface bubbles from melt and pour soap, I've not seen it do anything to bubbles in CP.
Works for CP aswell, provided that trace is relatively thin.

Actually, my usual antibubble strategy is thumping the soap batter before pouring to make the bubbles rise and spraying with alcohol to kill them. Works everytime.
 
Back
Top