fail

Soapmaking Forum

Help Support Soapmaking Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. sanjosedave

    HP Batch Fail - HELP

    I "made" the attached recipe today (see Recipe2.jpg). I carefully measured the oils and placed them in the crock pot which was on low. I waited until all the solid oils had melted and then poured the lye water in. Everything looked good at that point. I immersed the stick blender and turned it...
  2. S

    Body Butter Blend and Dead Skin

    Hello I am in desperate need of assistance. I made a body butter blend that consisted of 1/4 cup of Mango butter 2tbsp of Flaxseed Oil, 2tbsp of Olive Oil 1tbsp of Manuka Honey, teaspoon of liquid vitamin k 1 teaspoon of Vitamin E oil and Essential oils lavender,lemon and helichrysum Butter...
  3. M

    Made my first batch yesterday(failed?)

    Hello my name is Ashley. I made my first batch of soap yesterday. I used a recipe that I used off of SoapQueen.com which was 100% coconut oil, aloe Vera mantra swirl. I also used a scent of my own choice cucumber melon. However, I noticed when I unmolded it 24 hours later it was stone! I don't...
  4. DiddlyO

    Not sure if this is gross, but...

    I have been doing a lot of reading about soap, silk, shampoo bars etc.. And I'm quite prone to experimentation... I'm on my fifth or so batch of soap and thought I would try a shampoo bar. So ambitiously, I thought I would make it with beer as the liquid. While reading I discovered people are...
  5. M

    CP fail plz help!

    So I made cp soap and after 24 hrs the soap was still soft ,I tested it by putting my tongue to it and I burned it bad. :( Anyways I let it sit another 2 days and today I saw small crystals forming on the top and lots of liquid on the bottom and a bit on top. What happened to it? Can I...
Back
Top